Initial Troubleshooting Steps When Server Power Socket Is Getting Yellow Light/Red Light.

Initial Troubleshooting Steps When Server Power Socket Is Getting Yellow Light/Red Light.

Power Socket

Power Socket is the point on server where the power cable is plugged in. These sockets are part of the server's power supply unit (PSU) and are essential for delivering electrical power to the server.

Server with different colored lights besides power supply typically indicate the status of the power supplies.

  1. Green Light: Power socket is functioning properly and  is providing power to the server. 
  2. Yellow Light: There is an issue with power supply or Indicates a warning .Problem that needs attention.
  3. Red Light: This indicates that power supply is having a critical fault or failure.

Initial trouble shooting steps when it is getting Red light/Yellow Light.

  1. Check Connections: Ensure that the power cable is securely connected to the power supply unit (PSU) and to the power source.
  2. Inspect the Power Supply: If the power supply has an on/off switch, make sure it is in the "on" position. Check for any visible signs of damage or overheating.
  3. Monitor Server Logs: Check the server’s event logs, check for any error messages or warnings related to the power supply.
  4. Swap Power Cables: Try using a different power cable to rule out a faulty cable.

    • Related Articles

    • Initial steps for the troubleshooting/detecting error if NIC card is not detecting on server.

      What is NIC(Network interface Card) Card? A network interface card is a piece of hardware that allows computers to communicate with other devices on a network. It can also be called an Ethernet card, LAN card, or network adaptor. A NIC provides a ...

    • Troubleshooting steps if GPU is not detecting

      Steps to check if GPU is not detecting on the system Parameters for demonstrating the Troubleshooting System Model : ASRock TRX40 Creator AMD sTRX4 Socket ATX GPU : PNY A6000 x 4 Verify the GPUs on the system using below steps Execute the below ...

    • Link Aggregation Creation and Troubleshooting Steps of Asustor AS6512RD

      Create Link Aggregation on Asustor AS6512RD Steps to Create Link Aggregation Login to your asustor device Go to Setting > Network > Network Interface > Add > Create Link Aggregation Select an aggregation mode from the drop-down list. Round-Robin: ...

    • Configuring BMC in ASUS Server

      To configure the Baseboard Management Controller (BMC) IP address on an ASUS server, initially access the server's BIOS/UEFI settings and then configure the BMC network settings. Here's a step-by-step instructions Server BMC Configuration preparation ...

    • Troubleshooting storage drive not detected

      A storage drive not being detected can be due to a variety of factors, and the solution depends on the underlying cause. Here are some of the major parameters or reasons why a storage drive may not be detected and the corresponding solutions: Cable ...