AOC-A25G-B2SM has Standby Power disabled by default due to potential overheating risk
Do
not change the jumper settings for AOC-A25-B2SM cards.
Follow the procedure to validate the AOC.
- Do NOT use unsupported jumper setting.
- Do NOT use BIOS and BMC to detect NIC presence before boot.
- To avoid booting Production OS after service: use F11 Boot Menu to boot EFI shell. BMC should then display NIC status. Type “exit” at EFI shell to return to BIOS setup. NIC should be present at this point because EFI was initialized.
- Wait for BMC to refresh after boot. Once Sensors come online, the card should be detected.
Related Articles
Configuring BMC in ASUS Server
To configure the Baseboard Management Controller (BMC) IP address on an ASUS server, initially access the server's BIOS/UEFI settings and then configure the BMC network settings. Here's a step-by-step instructions Server BMC Configuration preparation ...How to resolve not detecting issue of AOC cards in Supermicro servers
AIOM cards in Supermicro systems usually fail to detect because of power state, seating or mechanical fit, slot–CPU mapping, BIOS options, or card support/firmware. Add on cards used in Supermicro servers AS-4125GS-TNRT/TNRT1/TNRT2 AOC-A25G-B2SM-O ...Creating RAID using an add-on Card through the BIOS
Creating Raid Configuration using an Add-on RAID Card through BIOS To create a RAID configuration using an add-on RAID card through the BIOS, you'll typically follow these general steps. Keep in mind that specific steps can vary based on the RAID ...What is BMC and How to generate BMC Logs
BMC (Baseboard Management Controller) The Baseboard Management Controller (BMC) is a specialized microcontroller embedded on a server’s motherboard that enables remote management and monitoring of the server's hardware, even when the server is ...AMD Motherboard Voltage and Power Settings Guide
By default, many motherboard manufacturers stray from the voltage and power guidelines set by AMD for extra performance or stability. This however, results in higher thermals and less efficiency. Following are some quick settings you need to change, ...